Case CX20B, CX22B and CX27B
WORKSHOP MANUAL - MANUALE DI OFFICINA - MANUEL DE REPARATION - REPARATURANLEITUNG
CASE HYDRAULIC EXCAVATOR CX31B - CX36B - WORKSHOP MANUAL - MANUALE DI OFFICINA - MANUEL DE REPARATION - REPARATURANLEITUNG - English, Italian, French, Spanish and German Workshop Manual, in PDF format, to excavators Case CX20B, CX22B and CX27B CONTENTS: 24. COMPONENTS SYSTEM - 24.1 HYDRAULIC COMPONENTS --- 24.1.1 HYDRAULIC PUMP --- 24.1.2 PILOT VALVE (ATT) --- 24.1.3 PILOT VALVE (TRAVEL) --- 24.1.4 CONTROL VALVE --- 24.1.5 SLEWING MOTOR --- 24.1.6 TRAVEL MOTOR --- 24.1.7 SWIVEL JOINT --- 24.1.8 CYLINDER - 24.2 ELECTRICAL EQUIPMENT --- 24.2.1 ELECTRICAL EQUIPMENT LIST --- 24.2.2 SPECIFICATIONS ELECTRICAL EQUIPMENT 0071_A3 - This page is blank because of editing convenience. --- 71.1 HYDRAULIC CIRCUIT DIAGRAM --- 71.1.1 STANDARD SPECIFICATION --- 71.1.2 HYDRAULIC CIRCUIT OPERATION --- (1) NEUTRAL CIRCUIT --- (2) TRAVEL CIRCUIT: Travel forward operation at travel 2nd speed --- (3) SLEWING CIRCUIT: Slewing left operation --- (4) BUCKET CIRCUIT: Bucket digging operation --- (5) BOOM CIRCUIT: Boom up operation --- (6) ARM CIRCUIT: Arm in operation --- (7) SWING CIRCUIT: Boom swing left operation --- (8) DOZER CIRCUIT: Dozer down operation --- (9) COMBINED OPERATION CIRCUIT: Travel (forward) 1st speed / Dozer down operation --- (10) COMBINED OPERATION CIRCUIT: Travel (forward) 1st speed / Boom up operation --- (11) NIBBLER/BREAKER OPERATION CIRCUIT: Nibbler close operation --- 71.1.3 SCHEMATIC PIPING FOR HYDRAULIC SYSTEM --- 71.2 ELECTRIC CIRCUIT DIAGRAM --- Fig. 71- 4 --- Fig. 71- 13 (1/3) --- Fig. 71- 13 (2/3) --- Fig. 71- 1 --- Fig. 71- 2 --- Fig. 71- 3 --- Fig. 71- 5 --- Fig. 71- 6 --- Fig. 71- 7 --- Fig. 71- 8 --- Fig. 71- 9 --- Fig. 71- 10 --- Fig. 71- 11 --- Fig. 71- 12 --- Fig. 71- 13 (3/3) 0051_ENGINE - 51.1 General - 51.2 Inspection and Adjustment - 51.3 Troubleshooting - 51.4 Disassembly, Inspection and Reassembly of Engines - 51.5 LUBRICATION SYSTEM - 51.6 COOLING SYSTEM - 51.7 FUEL INJECTION PUMP/GOVERNOR - 51.8 TURBOCHAGER: Disassembly, inspection and reassembly - 51.9 STARTING MOTOR - 51.10 ALTERNATOR - 51.11 ELECTRIC WIRING - 51.12 SERVICE STANDARDS - 51.13 TIGHTENING TORQUE for BOLTS and NUTS
Case CX20B CX22B CX27B - Workshop Manual
inicio - index
coche - car
moto
4x4
quad - buggy
cami n - truck
e-mail